Town & Country V6-3.8L (2009)
1. On the right side only if removed, position the lower seat belt anchor bracket (8) onto the floor panel (7) near the base of the C-pillar (10).
2. On the right side only if removed, install and tighten the screw (9) that secures the anchor bracket to the floor panel. Tighten the screw to 39 Nm
(29 ft. lbs.).
3. Position the second row outboard seat belt and retractor (5) to the C-pillar as a unit.
4. Engage the tab on the retractor bracket into the keyed slot in the C-pillar.
5. Install and tighten the screw (6) that secures the retractor to the lower C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
6. Reinstall the upper trim (1) onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Installation.
7. Position the second row seat belt turning loop onto the height adjuster (2) on the upper C-pillar.
8. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
9. Snap a new trim cover (4) onto the height adjuster on the upper C-pillar.
10. Reinstall the trim panel (2) onto the quarter inner panel. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage
Compartment Trim/Quarter Trim Panel - Installation.
11. Position the seat belt and retractor (5) lower anchor to the anchor bracket (4) on the floor panel (right side only) or directly to the floor panel (left
side only) near the base of the C-pillar (1).
12. Install and tighten the screw (3) that secures the seat belt lower anchor to the anchor bracket or to the floor. Tighten the screw to 39 Nm (29 ft.
lbs.).
Second Row - Swivel
SECOND ROW - SWIVEL
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
