Town & Country V6-3.8L (2009)
CAUTION: Be certain that the brake lamp switch plunger is in contact with the flag bracket on the brake pedal arm prior to rotating the
plunger adjustment release lever. If the plunger is not contacting the flag bracket, depress and hold the brake pedal while
manually pulling the plunger out from the switch body to the fully extended position. Then release the brake pedal, but do not pull
it upward.
6. Rotate the plunger adjustment release lever clockwise until it locks into place. The lever should be parallel to the brake lamp switch connector
receptacle. This action will set the switch plunger length to a final adjustment position and cannot be undone. If not performed properly the first
time, a new brake lamp switch must be installed.
7. Reconnect the wire harness connector to the brake lamp switch.
8. Reconnect the battery negative cable.