Town & Country V6-3.8L (2009)
4. Place the battery tray (3) into mounted position.
5. Install the one nut (1) and two bolts (2) securing the battery tray (3) to the frame rail (4).
6. Tighten the nut to 12 Nm (105 in. lbs.).
7. Tighten the bolts to 12 Nm (105 in. lbs.).
8. Install the battery. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Battery - Installation.
9. Raise and support vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
NOTE: Before installing power steering return hose on power steering gear, wipe clean connection with a lint-free cloth and replace O-ring.
Lubricate O-ring using clean power steering fluid.
10. Install return hose (5) into power steering gear (3) port. Thread pressure hose tube nut into gear, but do not tighten at this time.
11. Position return hose routing clamp and install screw (1) securing return hose routing clamp to rear of ABS support bracket. Tighten screw to 8 Nm
(71 in. lbs.).
12. Tighten return hose (5) tube nut at steering gear (3) to 31 Nm (23 ft. lbs.).
13. Lower vehicle.
14. Install negative (-) battery cable on negative battery post.
15. Fill and bleed power steering system. See: Service and Repair/Steering - Power Steering System Bleeding
16. Inspect for leaks.
Return Hose - Cooler to Reservoir
COOLER TO RESERVOIR
