Town & Country V6-3.8L (2009)
10. On each side of vehicle, attach the outer tie rod (5) to the knuckle (2). Start a NEW nut (1) onto the outer tie rod stud. While holding the stud
stationary, tighten the nut using a wrench. Using a crowfoot wrench on a torque wrench, tighten the nut to 75 Nm (55 ft. lbs.). Then, tighten the nut
an additional 245° turn after that torque is met.
11. Attach the stabilizer bar link (1) at each end of the stabilizer bar (3). At each link, install and tighten the nut (2) while holding the stabilizer bar
link lower stud stationary. Tighten the nuts to 88 Nm (65 ft. lbs.).
12. On each side of vehicle, install the tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and
Wheels - Installation. Install and tighten the wheel mounting nuts (3) in proper sequence to 135 Nm (100 ft. lbs.).
13. Lower vehicle.
