Town & Country V6-3.8L (2009)
Constant Velocity Joint Boot: Service and Repair
Drive Shaft, Inner Boot - Removal
REMOVAL
1. Remove the halfshaft requiring boot replacement from the vehicle. See: Service and Repair/Half Shaft - Removal
2. Remove large boot clamp which retains inner tripod joint sealing boot (3) to tripod joint housing (1) and discard.
3. Remove small clamp which retains inner tripod joint sealing boot to interconnecting shaft and discard.
4. Remove the sealing boot from the tripod housing and slide it down the interconnecting shaft.
5. Slide the tripod joint housing off the spider assembly (2) and the interconnecting shaft.
6. Remove snap-ring (3) which retains spider assembly to interconnecting shaft. Do not hit the outer tripod bearings in an attempt to remove
spider assembly from interconnecting shaft.
