Town & Country V6-3.8L (2009)
Windshield Washer Reservoir: Service and Repair
Windshield Washer Reservoir - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Disconnect the washer hose from the hose clip located on the front fender side shield.
3. Hoist and support vehicle on hoist or jack stands.
4. Remove the right front wheel and tire assembly See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and
Wheels - Removal.
5. Disconnect the left right front wheelhouse splash shield and move aside See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service
and Repair/Splash Shield - Removal.
6. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the
front (outboard) washer pump port allowing the washer fluid to drain into a container through a temporary jumper hose connected to the washer
pump port.
7. Disconnect the electrical body harness connectors to the washer pump motor and the fluid level sensor. Slide the red lock on the connector to the
release position, then, depress the black tab and pull the connector off the pump or sensor.
8. Remove the two reservoir mounting screws.
9. Disconnect the reservoir from the body mount by raising the reservoir upward slightly and then down so that the reservoir filler neck and front
washer hose pull through the opening in the front fender side shield.