Town & Country V6-3.8L VIN L (2006)
a) When breaking the tire bead loose from the wheel rim, avoid using the Bead Breaker in the area of the sensor. That includes both front and
rear beads of the tire.
b) When preparing to dismount the tire from the wheel, carefully insert the mounting/dismounting tool at the valve stem ±10° (Fig. 19), then
proceed to dismount the tire from the wheel. Use this process on both the upper and lower tire beads.
3) Remove sensor nut retaining sensor to wheel (Fig. 20). While removing nut, hold pressure against rear of metal valve stem to keep valve stem
from pushing rearward, damaging antenna strap.
4) Remove sensor from wheel (Fig. 20).
INSTALLATION
Fig. 21 Sensor Mounting - Exploded View
NOTE: Before reinstalling an existing tire pressure sensor, replace seal and metal washer at base of valve stem to ensure proper sealing (Fig. 21).
1) Wipe area clean around sensor/valve stem mounting hole in wheel. Make sure surface of wheel is not damaged.
Fig. 22 Tire Pressure Sensor
