chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Power Sliding Door Module|Service and Repair > < Power Sliding Door Module|Description|Page 10165
Page 2
background image

-

The front overhead console lockout switch must be in the "UNLOCKED" position in order for the power sliding door systems B-pillar switches to
function.

-

If multiple obstacles are detected during the same power open or close cycle the power sliding door may go into full manual mode.

-

If severe Diagnostic Trouble Codes (DTC) are stored in the PSDM the power sliding door may go into full manual mode.

-

Due to the high pressure created in the passenger compartment with the blower motor on high, the power sliding door may not complete a power
close cycle unless a window is cracked, allowing the pressure to escape. This situation will only be experienced on some vehicles, or vehicles with
brand new side door weather seals installed.

The hard wired circuits for the power sliding door switches may be diagnosed using conventional diagnostic tools and procedures. However,
conventional diagnostic methods will not prove conclusive in the diagnosis of the electronic controls and communication between other modules and
devices that provide some features of the power sliding door system. The most reliable, efficient, and accurate means to diagnose the power sliding door
switches or the electronic controls and communication related to the power sliding door system operation requires the use of a diagnostic scan tool.

POWER SLIDING DOOR SYSTEM WARNINGS

WARNING: Always disconnect the negative battery cable before attempting any power sliding door system service.

WARNING: Extreme care must be taken to prevent objects from entering the doors path once the door reaches the cinch motor contact
(approximately 1 inch before fully closed). Never place objects in the power sliding door when cinching closed. The obstacle detection function
is inoperative during the cinch phase and damage to the vehicle, power sliding door system or components and/or personal injury may occur.

WARNING: Never attempt to enter or exit the vehicle while the power sliding door is in motion. You could damage the power sliding door
system or components and/or cause personal injury.

WARNING: Never attempt to drive away with the power sliding door in motion. You could damage the power sliding door system or
components and/or cause personal injury.

Power Sliding Door Module|Service and Repair > < Power Sliding Door Module|Description|Page 10165