Town & Country V6-4.0L (2008)
Power Sliding Door Module: Service and Repair
Power Sliding Door Module - Installation
INSTALLATION
NOTE: Any time a power sliding door component is removed, replaced, door adjustment is performed or diagnostic trouble codes are
addressed and erased, a learn cycle must be performed. The power sliding door learn cycle enables the power sliding door control module to learn or
relearn critical information (travel limits, resistance to door travel, door position, etc.) which allows the system to perform properly and safely. See:
Service and Repair/Procedures for the appropriate procedure.
1. Position the power sliding door control module onto the drive assembly (2) and install the retaining screws (1).
2. Connect the power sliding door control module (1) electrical connectors (3).
3. Install the power sliding door drive assembly,See: Power Sliding Door Drive Assembly/Service and Repair/Power Sliding Door Drive Assembly -
Installation.
4. Connect the battery negative cable.
5. Perform the power sliding door learn cycle,See: Service and Repair/Procedures.