Town & Country V6-4.0L (2008)
15. Center the steering gear (2) mounting bosses over the mounting holes in the crossmember and install two steering gear mounting bolts (1). Tighten
the mounting bolts to 75 Nm (55 ft. lbs.).
16. Position the power steering pressure hose routing clamp(s) (4.0L engine only uses one) on the rear of the crossmember. Install and tighten the
screw(s) to 8 Nm (71 in. lbs.).
17. Position the power steering return hose routing clamp on the rear of the ABS ICU mounting bracket. Install and tighten the screw (1) to 8 Nm (71
in. lbs.).
18. Install the rear engine mount.See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and
Repair/Engine Mount - Installation
19. Position the heat shield (1) over the steering gear (2). Install the mounting screws and push-pins. Tighten the screws to 8 Nm (71 in. lbs.).
