Town & Country V6-4.0L (2008)
1. Screw the height adjust motor gearbox spindle (1) in or out as necessary until the motor retaining screws (3) and spindle screw (4) holes are
aligned and all fasteners can be installed.
2. Position the height adjust motor and gearbox assembly (2) onto the seat track.
3. Install the motor retaining screws (3). Tighten the screws to 12 Nm (106 in. lbs.).
4. Install the height adjust motor gearbox spindle (1) retaining screw (4). Tighten the screw to 17 Nm (150 in. lbs.).
5. Connect the motor electrical connector.
6. Install the power seat,See: Service and Repair/Removal and Replacement/Seat - Installation.
7. Verify proper power seat operation.
Power Seat Tilt Motor - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat
air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may
result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable.
2. Remove the inoperative front seat assembly,See: Service and Repair/Removal and Replacement/Seat - Removal.
3. Disconnect the front tilt motor electrical connector.
4. Remove the front tilt motor gearbox spindle (3) retaining screw (2).
5. Remove the motor retaining screws (4).
6. Remove the front tilt motor and gearbox assembly (1) from the seat track.
Power Seat Tilt Motor - Installation
INSTALLATION