Town & Country V6-4.0L (2008)
10. If required, remove the wire harness retaining bracket (4) from the bottom of the seat riser (2).
11. Remove the two nuts (1) and the two bolts (3) that secure the seat riser to the seat track and remove the riser.
Installation
INSTALLATION
NOTE: Driver seat shown in illustrations. Passenger seat similar.
1. Position the seat riser (2) to the seat track and install the retaining two nuts (1) and bolts (3). Tighten the nuts and bolts to 48 Nm (35 ft. lbs.).
2. Install the wire harness retaining bracket (4) onto the seat riser.
NOTE: Heated seat shown. Non-heated seat similar.
3. If removed, install the seat track position sensor (8).
4. Position the seat track assembly (6) to the bottom of the seat cushion frame (5). Make sure the seat track is properly located and that the plastic
isolators are correctly installed.
5. Engage the four seat track mounting brackets (3) to the bottom of the seat cushion frame and install the retaining bolts (2). Tighten the bolts to 28
Nm (21 ft. lbs.).
6. Install the wire harness (7) to the bottom of the seat cushion frame and to the seat riser (9) and connect the wire harness connectors to the power
seat motors (1) and the seat track position sensor.
7. If equipped, install the heated seat module (4) onto the bottom of the seat cushion frame.
