Town & Country V6-4.0L (2008)
Seat Track: Service and Repair
Seat Track - Removal
Manual - Front Seat
REMOVAL
NOTE: Outboard seat track shown in illustrations. Inboard seat track similar.
1. Remove the seat from the vehicle and place it on a workbenchSee: Service and Repair/Removal and Replacement/Seat - Removal.
2. Remove the seat cushion and coverSee: Seat Cushion/Service and Repair/Seat Cushion / Cover - Removal.
3. Remove the riser from the seat track (3)See: Service and Repair/Removal and Replacement/Seat Riser - Removal.
4. If servicing the outboard seat track, remove the nut that secures the seat back to the recliner (2).
5. Remove the pivot bolt (1) that secures the seat back to the seat track.
6. If required, remove the seat adjust handle (2) from the seat track (3).
Power - Front
REMOVAL
WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat
air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may
result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Driver seat shown in illustrations. Passenger seat similar.