Town & Country V6-4.0L (2008)
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool # C-4755) or equivalent, gently pry the upper edge of the 2nd row heated seat switch bezel (4) away from the
sliding door trim panel (6).
3. Once the upper edge is free from the trim panel, rock the switch and bezel out of the sliding door trim panel opening.
4. Disconnect the heated seat switch wire harness connector (5).
5. From the back side of the switch bezel (4), gently pry the switch (3) free from the bezel.
