Town & Country V6-4.0L (2008)
6. Remove the single mounting bolt (1) securing the ICU (2) to the mounting bracket (3).
7. Lift the ICU off the mounting bracket, dislocating the mounting pins from the grommets in the bracket.
8. If ABM and HCU need to be separated,See: Overhaul/Disassembly
Integrated Control Unit (ICU) - Installation
INSTALLATION
1. Position the ICU (2) above the mounting bracket (3) in the vehicle. Insert the mounting pins on the ICU into the grommets mounted in the bracket,
then install the single mounting bolt (1). Tighten the mounting bolt to 11 Nm (97 in. lbs.).
CAUTION: Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.
2. Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.
