Town & Country V6-4.0L (2008)
CAUTION: When installing a new brake caliper it is necessary to bleed the brakes using a special procedure which has been integrated to this
installation procedure.
1. Remove the outboard pad (5) from the adapter bracket.
CAUTION: Use care when installing the caliper (2) onto the adapter bracket to avoid damaging the guide pin boots.
2. Install the disc brake caliper (2) over the inboard brake pad on the brake caliper adapter bracket and the brake rotor.
CAUTION: When removing or installing a caliper guide pin bolt, it is necessary to hold the guide pin stationary while turning the bolt.
Hold the guide pin stationary using a wrench placed upon the pin's hex-shaped head.
3. Align the caliper guide pin bolt holes with the adapter bracket. Install the upper and lower caliper guide pin bolts (1). Lightly tighten the guide pin
bolts at this time.
4. Install the banjo bolt (3) connecting the brake flex hose (2) to the brake caliper (1). Be sure to install a NEW brake hose washer on each side of the
hose fitting as the banjo bolt is guided through the fitting. Thread the banjo bolt into the caliper and tighten it to 24 Nm (18 ft. lbs.).
