chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

A/C Line - Removal|Page 8249 > < A/C Line - Removal
Page 2
background image

1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant systemSee: Service and Repair/Procedures/Refrigerant System Recovery.
3. Remove the air cleaner housing and inlet duct from the engine compartment.
4. Remove the bolt (1) that secures the front section of the A/C liquid line (2) to the A/C receiver/drier (3).
5. Disconnect the front section of the A/C liquid line from the A/C receiver/drier and remove and discard the O-ring seal.

6. Remove the nut (1) that secures the front section of the A/C liquid line (3) to the condenser tapping block (2) located in the right front corner of

the engine compartment.

7. Disconnect the front section of the A/C liquid line from the A/C condenser and remove and discard the O-ring seals and gasket.
8. Disengage the front section of the A/C liquid line from the retaining clip located near the right frame rail and remove the liquid line from the

engine compartment.

9. Install plugs in, or tape over the opened refrigerant line fittings and the condenser and receiver/drier ports.

REAR SECTION

10. Disconnect and isolate the negative battery cable.
11. Recover the refrigerant from the refrigerant systemSee: Service and Repair/Procedures/Refrigerant System Recovery.
12. On models equipped with the rear heating-A/C system, disconnect the A/C liquid line from the underbody liquid lineSee: Underbody Line.
13. Remove the air cleaner housing and inlet duct from the engine compartment.
14. Disconnect the wire harness connector (1) from the A/C pressure transducer (2) located on the fitting on the rear section of the A/C liquid line (3)

at top of the A/C receiver/drier (4).

15. Remove the A/C pressure transducer from the rear section of the A/C liquid line and remove and discard the O-ring seal.
16. Remove the bolt (5) that secures the rear section of the A/C liquid line to the A/C receiver/drier
17. Disconnect the rear section of the A/C liquid line from the A/C receiver/drier and remove and discard the O-ring seal.

A/C Line - Removal|Page 8249 > < A/C Line - Removal