Town & Country V6-4.0L (2008)
NOTE: If the foam seal around the heater core are deformed or damaged, it must be replaced.
5. Carefully install the heater core (1) into the driver side of the air distribution housing (2).
6. Position the front of the heater core cover (5) to the front of the HVAC housing (2) and engage the retaining tab that secures the cover to the
housing.
7. Install the heater core cover to the driver side of the air distribution housing (3) and install the two screws (4) that secure the cover to the housing.
Tighten the screws to 1.2 Nm (10 in. lbs.).
NOTE: If the foam seal from the front of the HVAC housing is deformed or damaged, it must be replaced.
8. Install the foam seal (1) onto the front of the HVAC housing.
9. Install the A/C expansion valveSee: Expansion Valve/Service and Repair/Plumbing - Front/Installation.
10. Install the HVAC housing.
Front Air Inlet Housing Removal
HOUSING-AIR INLET
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions could result in possible personal
injury or death.
NOTE: The air inlet housing must be removed from HVAC housing for service of the recirculation-air door.
