Town & Country V6-4.0L (2008)
b.
No >>> Proceed to Step # 10
NOTE:
If necessary, refer to the detailed wire splice information available in DealerCONNECT > TechCONNECT under: Wiring Tab > Wiring Diagram
Information > Wire > Standard Procedure > Wire Splicing for detailed instructions.
5.
Replace the MT sensor connector using p/n 05014002AA. Cut the VT/LG wire (Cavity # 1) close to the connector.
a.
Cut one of the new terminal wires (supplied in kit p/n 05014002AA) to an appropriate length.
b.
Remove 0.5 in. (13 mm) of insulation from each of the wires.
c.
Place a piece of sealant lined heat shrink tubing, (supplied in kit p/n 05014002AA), on one side of the wire.
d.
Place the strands of wire overlapping each other inside of the splice band.
e.
Using crimping tool, p/n 10042 (or equivalent) crimp the splice band and wires together.
f.
Solder the connection together using rosin core type solder only.
g.
Center the heat shrink tubing over the joint and heat using a heat gun, heat the joint until the tubing is tightly sealed and sealant comes out of
both ends of the tubing.
6.
Install the new terminal in the new connector (supplied in kit p/n 05014002AA) in cavity # 1.
7.
Cut the VT/BR wire (Cavity # 2) close to the connector.
a.
Cut one of the new terminal wires (supplied in kit p/n 05014002AA) to an appropriate length.
b.
Remove 0.5 in. (13 mm) of insulation from each of the wires.
c.
Place a piece of sealant lined heat shrink tubing, (supplied in kit p/n 05014002AA), on one side of the wire.
d.
Place the strands of wire overlapping each other inside of the splice band.
e.
Using crimping tool, p/n 10042 (or equivalent) crimp the splice band and wires together.
f.
Solder the connection together using rosin core type solder only.
g.
Center the heat shrink tubing over the joint and heat using a heat gun, heat the joint until the tubing is tightly sealed and sealant comes out of
both ends of the tubing.
8.
Install the new terminal in the new connector in cavity # 2.
9.
Inspect the AAT sensor for corrosion. Does the AAT sensor show any signs of corrosion?
a.
Yes >>> Replace sensor with p/n 05149025AA. Proceed to Step # 10
b.
No >>> Proceed to Step # 10
10.
Clean and dry (with compressed air) AAT sensor and connector terminals.
11.
Attach connector to AAT sensor.
