Town & Country V6-4.0L (2008)
CAUTION: When removing nut (3) from stud of stabilizer bar link (2), do not allow stud to rotate in it's socket. Hold stud from rotating by
placing an open-end wrench on flat surface machined into stud.
5. Remove stabilizer bar link (2) from bracket on strut assembly (1). To do so, place an open-end wrench on flat surface machined into link's
mounting stud, then remove nut (3) while holding wrench in place. Push stud out of bracket.
CAUTION: The strut assembly-to-knuckle attaching bolts are serrated and must not be turned during removal. Proper removal is
required. Refer to the following steps for the correct method.
6. If servicing left strut:
a. While holding bolt heads stationary, remove two nuts (3) from bolts (2) attaching strut (1) to knuckle.
b. Remove two bolts (2) attaching strut (1) to knuckle using a pin punch.
7. If servicing right strut:
a. While holding bolt heads stationary, remove two nuts (3) from bolts (2) attaching strut (1) to knuckle.
b. Remove two bolts (2) attaching strut (1) to knuckle using a pin punch.
