Town & Country AWD V6-3.8L VIN L (2003)
Lock Cylinder Switch: Testing and Inspection
Door Cylinder Lock Switch Resistance
1. Visually inspect the switch for proper installation. Make sure it is seated on the rear of the key cylinder, with the tab of the door key cylinder
properly aligned with the slot on the door cylinder lock switch.
2. Disconnect the switch at the harness connector and check the resistance in each switch position.
CAUTION: Do not disconnect the switch from the rear of the door key cylinder. This switch is a one time use switch. Once it is removed from the rear
of the switch, it is not reusable and must be replaced. Test the switch at the harness connector.
