Town & Country AWD V6-3.8L VIN L (2003)
Fig.3 Center Bezel Outlets
4. If the vehicle is equipped with the optional ATC system, disconnect the ATC remote infrared temperature sensor jumper harness from the sensor
connector receptacle located on the bottom of the center outlet housing.
5. Remove the three screws that secure the bottom of the outlet housing to the center bezel.
6. Roll the bottom of the outlet housing upwards towards the top of the center bezel far enough to disengage the retainer features on the top of the
outlet housing from their receptacles at the top of the center bezel.
7. Remove the center bezel outlets and housing from the center bezel as a unit.
Fig.4 Demister Outlet
Demister Outlet
1. Using a trim stick or another suitable wide flat-bladed tool, gently pry the outer perimeter of the demister outlet away from the instrument panel
top pad until the snap features on the outlet are released.
2. Remove the demister outlet from the demister duct opening in the instrument panel top pad.
Front Door Rear Outlet
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the front door inner panel.
