Town & Country AWD V6-3.8L VIN L (2003)
10.
Disengage the HVAC wire harness from the routing clips molded into the outside of the HVAC housing components.
11.
Remove the three screws from the dash panel side of the unit that secure the top of the distribution housing to the inboard end of the evaporator
housing (Fig. 2).
12.
Pull the top of the distribution housing away from the evaporator housing far enough to disengage the two hook formations on the bottom of the
distribution housing from the two receptacles on the evaporator housing (Fig. 3).
13.
Remove the screw and washer from the upper pivot of the recirculation door.
14.
Remove the two screws that secure the upper half of the recirculation air door to the lower half of the door.
