Town & Country AWD V6-3.8L VIN L (2003)
9. Install and tighten the nut that secures the suction line and liquid line fittings to the stud on the expansion valve. Tighten the nut to 23 Nm (17 ft.
lbs.).
10. Remove the tape or plugs from the liquid line rear section fitting for the filter-drier and the filter- drier outlet port.
11. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the liquid line fitting.
12. Reconnect the liquid line fitting to the filter- drier outlet port on the top of the filter-drier.
13. Install and tighten the screw that secures the liquid line fitting to the filter-drier. Tighten the screw to 2 Nm (18 in. lbs.).
14. Reconnect the headlamp and dash wire harness connector for the A/C pressure transducer to the transducer on the front liquid line rear section.
15. Reconnect the drain tube to the wiper module drain on the right side of the engine compartment.
16. Reinstall the air cleaner housing into the right side of the engine compartment.
17. Reconnect the battery negative cable.
18. Evacuate the refrigerant system.
19. Charge the refrigerant system.