Town & Country AWD V6-3.8L VIN L (2003)
12. Support caliper to prevent the weight of the caliper from damaging the flexible brake hose.
13. Remove the rotor from the hub/bearing.
14. Remove driveshaft from rear drive line module and hub/bearing. Driveshaft is removed by first compressing the inner joint on the driveshaft and
removing it from the drive line module. Then, slide the outer joint of the driveshaft out of the hub/bearing.
15. Remove the hub/bearing to axle mounting bolts.
CAUTION: Corrosion may occur between the hub/bearing and the axle. If this occurs the hub/bearing will be difficult to remove from the axle. If the
hub/bearing will not come out of the axle by pulling on it by hand, do not pound on the hub/bearing to remove it from the axle. Pounding on the
hub/bearing to remove it from the axle will damage the hub/bearing. This damage will result in noise or failure of the hub/bearing. To remove a
hub/bearing which is corroded to the axle, lightly tap the disc brake caliper adapter using a soft faced hammer. This will remove both the disc brake
caliper adapter and hub/bearing from the axle. The hub/bearing will then need to be removed from the caliper adapter.
