Town & Country AWD V6-3.8L VIN L (2003)
Power Steering Fluid Cooler: Service and Repair
REMOVAL
1. Using a siphon pump, remove as much fluid as possible from the power steering fluid reservoir.
2. Raise vehicle.
3. Remove the hose clamps at the cooler and remove the hoses from the cooler inlet and outlet tubes.
4. Remove the 2 bolts attaching the power steering cooler cradle crossmember reinforcement. Remove the cooler.
INSTALLATION
1. Install the power steering fluid cooler on the cradle crossmember reinforcement. Install the mounting bolts and tighten to 11 Nm (100 in. lbs.).
2. Install power steering fluid hoses on the cooler. Be sure hose clamps are installed on hose past the upset bead on the power steering cooler tubes.
3. Lower the vehicle to a point where front tires are just off the ground.
4. Perform Power Steering Pump Initial Operation procedure.
