Town & Country AWD V6-3.8L VIN L (2003)
5. Install power steering pressure hose end into pump pressure outlet fitting. Thread tube nut into outlet fitting, but do not tighten at this time.
6. Attach pressure hose routing bracket to engine. Tighten bolt to 23 Nm (200 in. lbs.) torque.
7. Tighten hose tube nut at pump outlet fitting to 31 Nm (275 in. lbs.) torque.
8. Route hose behind cradle crossmember and start hose end into gear port. Do not tighten hose tube nut at this time.
9. Attach hose to suspension cradle crossmember and steel reinforcement using two routing clamps and bolts. Tighten clamp bolt at steel
reinforcement to 11 Nm (100 in. lbs.) torque. Tighten clamp bolt at cradle crossmember to 23 Nm (200 in. lbs.) torque.
10. Tighten hose tube nut at power steering gear port to 31 Nm (275 in. lbs.) torque.
11. Install front emissions vapor canister.
12. Lower vehicle.
13. Fill and bleed the power steering system using the Power Steering Pump Initial Operation Procedure.
14. Inspect system for leaks.