Town & Country AWD V6-3.8L VIN L (2003)
6. Install the disc brake caliper guide pin bolts. Tighten the guide pin bolts to a torque of 35 Nm (26 ft. lbs.).
7. Clean all foreign material off the threads of the outer C/V joint stub shaft. Install the washer and hub nut on the stub shaft of the outer C/V joint.
8. Lower vehicle.
9. Set the park brake. This is required to keep the driveshaft from rotating when tightening and torquing the hub nut and driveshaft inner joint to
driveling module mounting nuts.
10. Raise vehicle.
11. Tighten the driveshaft inner joint to drive line module output shaft mounting bolts to a torque of 61 Nm (45 ft. lbs.).
12. Tighten the outer C/V joint hub nut to a torque of 244 Nm (180 ft. lbs.).
13. Install the spring washeron the stub shaft of the outer C/V joint.
14. Install the nut retainer and cotter pinon the stub shaft of the outer C/V joint.
15. Install the wheel speed sensor on the hub/bearing and adapter. Install the wheel speed sensor attaching bolt. Tighten the wheel speed sensor
attaching bolt to a torque of 12 Nm (105 in. lbs.).
16. Install wheel and tire.
17. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 135 Nm (100 ft. lbs.).
18. Lower vehicle.
CAUTION: Before moving vehicle, pump the brake pedal several times to insure the vehicle has a firm brake pedal to adequately stop vehicle.
19. Road test vehicle to ensure proper operation of the brake system.
