Town & Country AWD V6-3.8L VIN L (2003)
Axle Shaft: Service and Repair
Removal and Installation - Rear Axle Shaft
REMOVAL
1. Lift vehicle on hoist so that the wheels hang freely.
2. Remove rear wheel.
3. Remove cotter pin, nut lock, and wave washer (Fig. 1).
4. Remove hub nut and washer.
CAUTION: The half shaft outer CV joint, when installed, acts as a bolt and secures the hub/bearing assembly. If the vehicle is to be supported or
moved on its wheels, install and torque a bolt through the hub. This will ensure that the hub/bearing assembly cannot loosen.
5. Remove inner half shaft retaining bolts (Fig. 2).
