Town & Country AWD V6-3.8L VIN L (2003)
1. Reinstall cover and tighten bolts to 28 Nm (250 inch lbs.) in the sequence shown in (Fig. 24). Retighten first bolt after all others are tight.
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.
2. Reinstall P.T.U. into vehicle.
3. Check and fill fluids as required.
Half Shaft Inner Seal
HALF SHAFT INNER SEAL
REMOVAL
The power transfer unit half shaft inner seal is the smaller of the two seals located on the inside of the end cover.
1. Remove power transfer unit from the vehicle.
2. Remove end cover bolts (Fig. 25).
