Town & Country AWD V6-3.8L VIN L (2003)
2. Install seal with a 1 1/16 inch socket (Fig. 28). The seal must be installed with the spring side of the seal facing end cover ball bearing. The seal
will bottom against a machined shoulder in the cover.
3. Clean sealing surfaces of the end cover and P.T.U. case. Apply a bead of Mopar Gasket Maker, Loctite Gasket Eliminator No. 518 or equivalent.
4. Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 inch lbs.) in the sequence shown in (Fig. 29). Retighten first bolt
after all other bolts are tight.
5. Reinstall P.T.U. assembly.
6. Check and fill fluids as required.
Input Shaft Cover Seal
INPUT SHAFT COVER SEAL
REMOVAL
The power transfer unit input shaft cover seal is the larger of the two seals located on the inside of the end cover. The differential bearing cup must be
removed to service this seal.
