Town & Country Transfer Case End Cover Seal Service and Repair
CAUTION: The original shim must be installed behind the bearing cup to maintain proper bearing preload.
4. Apply Mopar Gasket Maker, Loctite Gasket Eliminator No. 518 or equivalent to sealing surfaces of end cover.
5. Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 inch lbs.) in the sequence shown in (Fig. 37). Retighten first bolt
after all others are tight.
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.
Input Shaft End Seal
INPUT SHAFT END SEAL
REMOVAL
The input shaft end seal is located on the end of the input shaft.
1. Remove power transfer unit from the vehicle.
