Town & Country LWB AWD V6-3.8L VIN L (2000)
10. Remove handle from vehicle.
INSTALLATION
1. Place inside latch handle in position on vehicle.
2. Engage cable end into latch handle.
3. Engage cable casing end into latch handle.
4. Install push-in fastener to hold cable into latch handle.
5. Place latch handle in position on sliding door.
6. Install screw to hold top of inside latch handle to sliding door.
7. Install screws to hold bottom of inside latch handle to sliding door.
8. Engage cable end into bellcrank assembly.
9. Engage clip to hold cable end into bellcrank assembly.
10. Verify sliding door operation. Adjust as necessary.
11. Install sliding door trim panel.
