Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 13
14. Install screws to hold the patch to support squares (Fig. 13). Tighten screws until patch surface is flush with panel surface.
15. Allow epoxy to cure, and remove all screws.
Fig. 14
16. Using a 125 mm (5 in.) 24 grit disc grinder, grind a 50 mm (2 in.) to 75 mm (3 in.) wide and 2 mm (0.080 in.) deep path across the gaps around
the patch (Fig. 14). With compressed air, blow dust from around patch.
