Town & Country LWB AWD V6-3.8L VIN L (2000)
CAUTION: Disconnect the battery negative cable. Damage to accessory feed circuit can result.
1. Remove first row seat.
2. Remove second row seat, if equipped.
3. Remove sliding door sill trim panel.
4. Remove quarter trim bolster.
5. Remove C-pillar trim panel.
6. Remove D-pillar trim panel.
7. Remove first row seat belt anchor.
8. Remove second row seat belt anchor on long wheel base vehicle.
9. Remove screws attaching quarter trim to quarter panel from bolster area.
10. Remove screws attaching rear edge of quarter trim to attaching bracket.
11. Disengage hidden clips holding front of quarter trim to quarter panel rearward of sliding door opening.
12. Remove quarter trim from quarter panel.
13. Disconnect wire connector from accessory power outlet, if equipped.
14. Pass second row seat belt through slot in trim panel on long wheel base vehicle.
15. Pass first row seat belt through slot in trim panel.
16. Remove quarter trim panel from vehicle.
INSTALLATION
1. Position quarter trim panel on vehicle.
2. Pass first row seat belt through slot in trim panel.
3. Pass second row seat belt through access hole in trim panel on long wheel base vehicle.
4. Connect wire connector into accessory power outlet, if equipped.
5. Align locating pins on backside of trim panel to mating holes in inner quarter panel.
6. Engage hidden clips attaching front of quarter trim to quarter panel rearward of sliding door opening.
7. Install screws attaching rear edge of quarter trim to attaching bracket.
8. Install screws attaching quarter trim to inner quarter panel in bolster area.
9. Install second row seat belt anchor on long wheel base vehicle. Tighten all seat belt bolts to 39 N.m (29 ft.lbs.) torque.
10. Install first row seat belt anchor.
11. Install D-pillar trim panel.
12. Install C-pillar trim panel.
13. Install quarter trim bolster.
14. Install sliding door sill trim panel.
15. Install second row seat, if equipped.
16. Install first row seat. .
17. Connect the battery negative cable.
Quarter Trim Bolster
QUARTER TRIM BOLSTER
The speaker grille in the quarter trim bolster is not removable. The trim bolster must removed to service the speaker.
1. Place quarter trim bolster in position on vehicle.
2. Engage hook retainer attaching front of trim bolster to quarter trim panel, if applicable.
3. Engage hidden clips attaching trim bolster to quarter trim panel.
INSTALLATION
The speaker grille in the quarter trim bolster is not removable. The trim bolster must removed to service the speaker.
1. Place quarter trim bolster in position on vehicle.
2. Engage hook retainer attaching front of trim bolster to quarter trim panel, if applicable.
3. Engage hidden clips attaching trim bolster to quarter trim panel.
Rear Header Trim
REAR HEADER TRIM
REMOVAL
