Town & Country LWB AWD V6-3.8L VIN L (2000)
5. Remove the rear wheel speed sensor cable/ brake tube routing clips . Then unclip the speed sensor cable from the routing clips on rear brake tube.
CAUTION: If the speed sensor has seized, due to corrosion, do not use pliers on speed sensor head in a attempt to remove it. Use a hammer and
a punch and tap edge of sensor, rocking the sensor from side to side until free.
6. Remove the wheel speed sensor attaching bolt. If sensor head does not come loose, do not use pliers on the sensor head to loosen. Tap sensor head
from side to side to loosen.
7. Remove the wheel speed sensor from the rear bearing assembly.
8. Remove the speed sensor assembly from the vehicle.
INSTALL
CAUTION: Proper installation of wheel speed sensor cables is critical to continued system operation. Be sure that cables are installed in retainers.
Failure to install cables in retainers as shown may result in contact with moving parts and/or over extension of cables, resulting in an open circuit.
1. Install wheel speed sensor head. Note, the plastic anti rotation pin must be fully seated prior to installing the attaching bolt.
CAUTION: Prior to installing the speed sensor head attaching bolt, the plastic anti-rotation pin must be fully seated into the bearing flange.
2. Install the wheel speed sensor head attaching bolt. Tighten the attaching bolt to a torque 12 Nm (105 inch lbs.).
3. Check the air gap between the face of the wheel speed sensor and the top surface of the tonewheel. Air gap must be less then the maximum
