Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 32
(10) Reinstall front carrier cover into carrier case (Fig. 32). Install carrier retaining bolts and tighten to 12 Nm (105 inch lbs.).
Fig. 33
(11) Use seal puller 7794-A (Fig. 33) to remove the overrunning clutch seal and drive pinion seal. The overrunning clutch seal must be removed first to
gain access to the drive pinion seal. The overrunning clutch seal must be replaced after the drive pinion seal is installed, do not reuse old seal.
INSTALLATION
(1) Clean and inspect seal area.
