Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 36
(4) Apply a light coat of oil onto the overrunning clutch seal and install with Seal Installer 6508A. Seal must be installed with the spring side away
from the rear carrier case (Fig. 36).
(5) Clean pinion nut and pinion shaft threads with Mopar(R) Brake and Parts Cleaner, Loctite Cleaning Primer or equivalent.
(6) Apply Mopar(R) Lock and Seal Adhesive to both the pinion nut and pinion shaft threads.
(7) Install pinion and tighten nut to 380 Nm (280 ft. lbs.) torque.
(8) Wipe off all excess adhesive.
(9) Install overrunning clutch outer race and snap ring.
(10) Apply Loctite Sealer to overrunning clutch sealing surface and reinstall the overrunning clutch case to rear carrier case.
(11) Reinstall rear drive line module assembly into the vehicle.
(12) Check and fill all fluids as required.
Front Overrunning Clutch Seal
OVERVIEW
The rear drive line module must be removed to service this seal.
The front overrunning clutch seal is located in the overrunning clutch case.
REMOVAL
(1) Remove rear drive line module assembly from vehicle.
(2) Remove viscous coupling unit.
(3) Remove overrunning clutch cover assembly.
(4) Drain fluid from overrunning clutch case.
