Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 23
(2) Install new seal with special tool MD998334. Seal should be flush with outside edge of case (Fig. 23).
(3) Install rear torque shaft bearing and outer snap ring.
(4) Install overrunning clutch case onto torque tube. Tighten bolts to 28 Nm (250 inch lbs.).
(5) Install torque shaft inner snap ring.
(6) Slide dog clutch onto shaft and install snap ring.
(7) Slide overrunning clutch inner race onto shaft and install retaining snap ring (tapered end of inner race must face outward).
(8) Clean all sealing surfaces. Apply a bead of Mopar(R) Gasket Maker or equivalent and reinstall the overrunning clutch housing to the rear carrier
case. Install retaining bolts and tighten to 28 Nm (250 inch lbs.).
(9) Apply Mopar(R) Gasket Maker or equivalent and reinstall overrunning clutch cover. When installing cover be sure that the overrunning clutch
fork engages into the overrunning clutch dog.
(10) Install rear drive line module assembly into vehicle.
(11) Check and fill fluid levels as required.
