Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 50
(3) Tap on end cover ears to separate end cover from case (Fig. 50).
Fig. 51
(4) Pry out seal with a pry bar (Fig. 51).
INSTALLATION
(1) Clean and inspect seal area.
(2) Remove input shaft from housing and stand on soft block of wood. Install input shaft end seal with seal installer 5065 and handle C-4171.
(3) Lubricate seal lip after installing seal into input shaft.
(4) Clean sealing surfaces of the end cover and P.T.U. case. Apply a bead of Mopar(R) Gasket Maker, Loctite Gasket Eliminator No. 518 or
equivalent.
