Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 52
(5) Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 inch lbs.) in the sequence shown in (Fig. 52). Retighten first bolt
after all others are tight.
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.
(6) Reinstall P.T.U. assembly.
(7) Check and fill fluids as required.
Input Shaft Cover Seal
The power transfer unit input shaft cover seal is the larger of the two seals located on the inside of the end cover. The differential bearing cup must be
removed to service this seal.
The Power Transfer Unit must be removed from vehicle to perform this operation.
REMOVAL
