Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 42
(3) Reinstall the original bearing race and shim using special tool No. 6522 (Fig. 41) and (Fig. 42).
CAUTION: The original shim must be installed behind the bearing cup to maintain proper bearing preload.
(4) Apply Mopar(R) Gasket Maker, Loctite Gasket Eliminator No. 518 or equivalent to sealing surfaces of end cover.
Fig. 43
(5) Place end cover onto P.T.U. case and install bolts. Tighten bolts to 28 Nm (250 inch lbs.) in the sequence shown in (Fig. 43). Retighten first bolt
after all others are tight.
CAUTION: When end cover is installed be careful not to damage the P.T.U. Input Shaft Cover Seal.
(6) Reinstall P.T.U. assembly into vehicle.
(7) Check and fill fluids as required.
Input Shaft Seal
