Town & Country LWB AWD V6-3.8L VIN L (2000)
Fig. 35
(1) Install new seal with Seal Installer 5049 (Fig. 35).
(2) If the original flange is used, align index marks and press flange onto pinion. If a new flange is used disregard the alignment marks on the pinion
and press flange onto the pinion.
(3) Install flange nut and tighten to 244 Nm (180 ft. lbs.).
(4) Install rear cover. Use care not to cut rear cover O-Ring when installing rear cover into P.T.U. housing.
(5) Install rear cover retaining bolts and tighten to 28 Nm (250 inch lbs.).
(6) Install propeller shaft.
(7) Check and fill fluids as required.
