Town & Country LWB FWD V6-3.3L VIN G Flex Fuel (1999)
Inverted Double Wall Flare And ISO Flare Tubing Connections
To make a double inverted tubing flare. Open handles of Flaring Tool, Special Tool C-4047 or equivalent. Rotate jaws of tool until the mating jaws of
tubing size are centered between vertical posts on tool. Slowly close handles with tubing inserted in jaws but do not apply heavy pressure to handle as
this will lock tubing in place.
Place gauge (Form A) on edge over end of brake tubing. Push tubing through jaws until end of tubing contacts the recessed notch in gauge matching
the tubing size. Squeeze handles of flaring tool and lock tubing in place. Place 3/16 inch plug of gauge (A) down in end of tubing. Swing compression
disc over gauge and center tapered flaring screw in recess of disc. Screw in until plug gauge has seated on jaws of flaring tool. This action has started
to invert the extended end of the tubing. Remove gauge and continue to screw down until tool is firmly seated in tubing. Remove tubing from flaring
tool and inspect seat. Replace any damaged tube routing clips.
ISO Tubing Flares
CAUTION: All ISO style tubing flares and are of metric dimensions. When performing any service procedures on vehicles using ISO style tubing
flares, metric size tubing of 4.75 mm MUST be used with metric ISO tube flaring equipment.
