Town & Country LWB FWD V6-3.8L VIN L (1999)
8. If hub/bearing cannot be removed from the axle by hand, use Remover Special Tool 8214 and following procedure to press the hub/bearing out of
the axle.
a. Place Special Tool 8214-1 over tone wheel and against cast flange of hub/bearing.
Put a dab of grease in the bolt pilot hole on the back of Special Tool 8214-1.
b. Insert Special Tool 8214-2 into the hole in the bottom of the end casting on the axle. Special Tool 8214-2 should be against and supported by
the axle plate when pressing the wheel bearing out of the axle. If Special Tool 8214-2 will not fit into the hole in the end casting, file or grind
the flashing from the hole until tool fits properly.
c. Align bolt in Special Tool 8214-2 with pilot hole in Special Tool 8214-1. Tighten bolt against Special Tool 8214-1.
d. Press hub/bearing out of axle by continuing to tighten bolt in Special Tool 8214-2 against Special Tool 8214-1.
9. Remove the hub/bearing from the rear axle and brake support plate.
