Town & Country LWB FWD V6-3.8L VIN L (1999)
Brake Caliper: Service and Repair
Cleaning and Inspection
Front
If a visual inspection does not adequately determine the condition of the lining, a physical check will be necessary. To check the amount of lining
wear, remove the wheel and tire assemblies, and the calipers.
Remove the shoe and lining assemblies.
Combined shoe and lining thickness should be measured at the thinnest part of the assembly.
When a shoe and lining assembly is worn to a thickness of approximately 7.95 mm (0.313 inch) it should be replaced.
Replace both shoe assemblies (inboard and outboard) on the front wheels. It is also necessary that both front wheel shoe assembly sets be replaced,
whenever shoe assemblies on either side of the vehicle require replacement.
If a shoe assembly does not require replacement, reinstall it, making sure each shoe assembly is returned to its original position.
Rear
Check for brake fluid leaks in and around dust boot area and inboard brake pad, and for any ruptures, brittleness or damage to the piston dust boot. If
the dust boot is damaged, or a fluid leak is visible, disassemble caliper assembly and install a new piston seal and dust boot, and piston if scored.
Check the guide pin dust boots to determine if they are in good condition. Replace if they are damaged, dry, or found to be brittle.
