Town & Country LWB FWD V6-3.8L VIN L (1999)
Right Park Brake Cable Removal From Body Bracket
6. To remove the right parking brake cable housing from the body bracket, slide a 14 mm box end wrench over the end of cable retainer to compress
the retaining fingers. The alternate method using an aircraft type hose clamp will not work on the right side of the vehicle.
7. Remove the brake shoes from the brake support plate.
8. Disconnect parking brake cable from parking brake actuator lever.
Removing Park Brake Cable From Brake Support Plate
9. Remove the parking brake cable housing retainer from the brake support plate using a 14mm wrench to compress the retaining fingers. Remove
the cable.
INSTALLATION
1. Install the rear parking brake cable in the brake support plate. Insert cable housing retainer into brake support plate making certain that cable
housing retainer fingers lock the housing and retainer firmly into place.
2. Attach the parking brake cable onto the parking brake actuator lever.
3. Install the brake shoes on the rear brake support plate.
4. Insert cable housing retainer into body outrigger bracket making certain that cable housing retainer fingers lock the housing firmly into place.
5. Connect the right rear parking brake cable to the connector on the intermediate parking brake cable.
6. Install the brake drum, then the wheel and tire assembly.
7. Remove the locking pliers from the front park brake cable. This will automatically adjust the park brake cables.
8. Lower the vehicle.
9. Apply and release park brake pedal 1 time. This will seat the park brake cables.
