Town & Country LWB FWD V6-3.8L VIN L (1999)
20.
Tighten the stabilizer bar link to strut attaching nut using a Torx Plus 40 IP bit and crowfoot to a torque of 88 Nm (65 ft. lbs.) (Figure 8).
21.
Install hydraulic brake hose and speed sensor cable routing brackets on the strut assembly brackets (Figure 1). Tighten the routing bracket
attaching bolts to a torque of 13 Nm (100 ft. lbs.).
22.
Install the wheel/tire assembly on the vehicle.
23.
Install and tighten the wheel mounting stud nuts in a cris-cross pattern until all nuts are torqued to half specification. Then repeat the tightening
sequence to the full specified torque of 135 Nm (100 ft. lbs.).
24.
Repeat step 2 through 23 for the other side strut, if necessary.
