Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
Sliding Door Handle: Service and Repair
Inside Latch Handle
INSIDE LATCH HANDLE
REMOVAL
1. Remove sliding door trim panel.
Fig. 26
2. Remove screws holding bottom of inside latch handle to sliding door (Fig. 26).
3. Remove screw holding top of inside latch handle to sliding door.
4. Disengage cable end from clip on bellcrank assembly.
5. Disengage cable end from bellcrank assembly.
6. Remove latch handle from sliding door.
7. Remove push-in fastener holding cable end to latch handle.
Fig. 27
8. Disengage cable casing end from latch handle (Fig. 27).
9. Disengage cable end from latch handle.