Town & Country SWB FWD V6-3.3L VIN G Flex Fuel (2000)
PROPORTIONING VALVE IDENTIFICATION CHART
7. With the aid of a helper, apply pressure to the brake pedal until a pressure of 6895 kPa (1000 psi) is obtained on the proportioning valve inlet
gauge. Then based on the type of brake system the vehicle is equipped with and the pressure specification shown on the following table, compare
the pressure reading on the outlet gauge to the specification. If outlet pressure at the proportioning valve is not within specification when required
inlet pressure is obtained, replace the proportioning valve.
8. Repeat steps 2 through 7 for the other proportioning valve of the assembly.
CAUTION: When mounting the original or a replacement proportion valve on the frame rail of the vehicle install the mounting bolts in only the
two forward holes of the mounting bracket. Proportioning valve split point pressure conversion is 1 bar is equal to 14.5 psi.
